De-dusting oil for Direct, Acid, Reactive – (V.S. base), Metal complex, disperse dyes. Because of lower surface tension, higher flash point and balanced HLB gives maximum efficient de-dusting effect on finer particles to co-aggulated which does not allow finer particles which are born at the time of un-loading the dyes in to dye – bath or at the time of packing & repacking.
Chemical Specification
01
Physical Appearance
Light Yellow
02
pH
7.5
03
Ionic Nature
Non ionic / Anionic
04
Specific Gravity
0.8611
05
Surface Tension of 1% Solution
34.71 32.56
06
Viscosity
With 4 D Cup. - 22 sec.
07
Flash Point
190° C
08
Solubility in Water
Form emulsion.
09
Stability in water
Emulsion is stable for more then 72 Hours.
10
Dyeing condition
for 60 Minute.
(i) Temp. Stability
Stable up to 130° C
(ii) At 4.5 pH
Stable
(iii) At 11 pH
Stable
(iv) Filtration test
(2/4 No. Filter Paper)
No residue.
Product Based on Octyl/Nonyl Phenol Base Emulsifier
Application:
The product can not be used for Mono-Chloro Triazynyl and Dichloro Triazynyl type of reactive dyes because it has a free – OH group which is condense with active chloro group of reactive dyes hence the dyes shows reduction in strength on storage.
Dosage:
10 gm to 20 gm per Kg of Finish Dyes.
Method of Application:
In Blender Operation.
Precaution:
Do not use for Basic Dyes, Oil Soluble Dye, Solvent Dyes and Pigments.
